YAMAHA OUTBOARDS
Works on these models: 90hp - 250hp Carb. Vmax, 2-Stroke, 4-Stroke, HPDI and Saltwater Series  with 3 RAM Trim/Tilt Systems

SUZUKI OUTBOARD
Works on this model: DF60HP - DF140hp Four Stroke - with 3 RAM Trim/Tilt Systems

Install on Port Side of Yamaha Outboards

1. Trim outboard to up position

2. Simply slide M-Y Wedge™ on Port side over Trim/Tilt piston of lower unit

3. M-Y Wedge™ will position and self-center, slide completely down

4. Trim outboard down until the rubber begins to compress and motor is secure

5. To remove M-Y Wedge™ simply trim outboard to up position and remove

6. Store M-Y Wedge™ in any boat compartment for convenience

Note: We recommend that you rotate M-Y Wedge™ 1/4 to 1/2 turn each use. This helps even the compression of the EPDM Rubber on the unit.

We also recommend that a small amount of grease be placed on the piston rod shaft and the base of M-Y Wedge™ to ease installation (if needed).

Yamaha Port Side - Trim/Tilt Piston
Self Centers

Lower Until Starboard Piston Retracks 1/4" to 1/2"
To Secure. Correct Height for Trailering.

No Need to Hold on to Anything!!!